MOUNTING INSTRUCTIONS
 
 
 
First make sure that it is at least 70 degrees and the bike is also warm.
 
Remove your Fireman Joes Firefighter Special Edition Emblem from the dash.
 
If nessesary you may use a hair dryer to warm surface and make insert more flexable.
 
CAUTION: Dont use heat gun to install insert
 
 
 
Clean chrome dash with alcohol or lacquer thinner to remove any wax or dirt.
 
 
 
 
 
Peel Memorial dash insert from backing.
IMPORTANT- when installing, place insert onto area with minimum pressure.
After insert is properly aligned then you can apply pressure to complete installation.
 
 
 
 
 
Lay back the top section of the insert.
Start instalation at the bottom of the speedo.
 
 
 
 
 
Next install sides, working your way down to the bottom.
 
 
 
 
 
Apply top section, working your way around the speedo. It helps to use
a small screw driver to position it.
 
Stand back and  admire your new dash.
 
Clean with soap and water
DONT use chemicals or wax products on insert.
 
CAUTION: This may cause a lump in your throat, and your eyes to water.